Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
hello guys, i just recently aquired a 2007 fx h/o with a blown motor. The lady that owned had someone throw sand down the oil sump. I got the ski for 900 bucks which i didnt think was a bad deal. I tore the motor down the oil pump is deffinetly bad, along with 2 main crank bearings, my main concern is a nice grove in the crank shaft. What ive been trying to reserch and had no luck is if any one has milled the crank and used oversized bearings. I found that yamaha has diffrent sized bearings accorrding to color code but i couldnt find any specs on the clearance for them including in the service manual! i would appreciate any incite from anyone that has experance with this! i would like to save the 1000 dollars for the crank.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.