Personal Water Craft Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter #1
The pistons on this virage has been stuck to the cylinder walls. Im not sure how long they have been like this, I purchased it in this condition. Does anyone have any ideas on how to free them?
 

·
Read Only
Joined
·
5,059 Posts
Soak them down with Liquid Wrench or PB Blaster and let it set, re apply, and sit. Prob. going to take a couple of days.
 

·
Read Only
Joined
·
5,059 Posts
if there's rust on the pistons, chances are extremely high that the bottom end is trash also. Any rust at all on the lower rod bearings or main bearings makes the crank useless.
 
1 - 4 of 4 Posts
Top