Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I just purchased a used 2008 Yamaha VX110 Deluxe waverunner. There is space in my slip at the marina where I keep my boat to also moor the waverunner. The problem is there is no place to install a lift and therefore I will need to leave (moor) in the water for up to 4 months (June-September). I am on a clean, freshwater lake (Lake St. Clair). I know the manufacturer recommends the waverunner be removed from the water and flushed out after each use, but does anyone have experience mooring their waverunner in a fresh water lake for extended periods of time. Any damage to gelcoat or mechanicals?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.