Personal Water Craft Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
12 Posts
check fuel filters, fuels lines, make sure everything on tight, especially around the fuel baffle/sending unit. Take the breather off and look into the carbs while running, should be able to see if its getting gas...actually sounds like not enough gas to me.
 

·
Registered
Joined
·
12 Posts
fbarnette said:
new carb kits in. still bogging down what should i look for next, what about the fuel pump. thanks


Check all the lines for blockage and cracks...blow through the lines, see if you can get the vaccum thing going...could be anything loose on the fuel sender, its lines, clamps etc...I thought I had faulty sender on an SPi...turned out clamp where the sender goes into the tank was just loose.
 
1 - 2 of 2 Posts
Top