Personal Water Craft Forum banner
1 - 3 of 3 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
I own a 94 slt750, and I had to remove the flywheel to change the bendix. While removing the flywheel, my puller split on the end and damaged the first 2 threads on the crank. Does anyone know the thread pitch and size of these threads. I need to get a die, since the nut will not begin to thread on, but I dont know the size or where to get it. Any help would be greatly appreciated. Francis.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.