Personal Water Craft Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
i have a 1993 sea-doo and am doing a little restoration on it and was wondering if theres any web sites you can get diagrams of the hole sea-doo

thanks :luke
 

·
Registered
Joined
·
163 Posts
Hmm, what kind of diagrams are you looking for? Wiring or just how it's put together?

Actually both of those things can be found in a Clymer's manual for that year. Those books are pretty cheap.

Not too sure of any websites with the stuff viewable for free, but if you tell me more of what you're looking for I might be able to dig something up.
 

·
Registered
Joined
·
22 Posts
Discussion Starter #4
it would be for diagrams of how its put togather
im pulling the drive shaft and hole back end off and am stuck on the drive shat and stuff
 

·
Registered
Joined
·
163 Posts
Well to remove the driveshaft you're going to need to remove the engine. The engine and coupling device holds the driveshaft in and prevents it from sliding forwards.
 

·
Registered
Joined
·
22 Posts
Discussion Starter #6
oh ok that helps alot
is what im doing is replacing the tube that the inperpeller sits in
if you had any other pointers or a quick list of how i should be doing it that would be amasing
 
1 - 6 of 6 Posts
Top