Personal Water Craft Forum banner
Cancel

Driveshaft coupler question

1940 Views 1 Reply 2 Participants Last post by  JUST-IN-TIME, 
T
OK. I got my new lower unit, stator on, new lightweight flywheel on, starter & flywheel cover on. Oops, can't tighten the driveshaft coupler now that I already covered up my flywheel nut. Shouldn't the coupler tighten itself once it gets running?
Reply
Save
Like
1 - 2 of 2 Posts
JUST-IN-TIME
no, u might be able to feed rope in the 1 cylinder to stop piston from going up and be able to tighten coupler
Reply
Save
Like
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Personal Water Craft Forum
A forum community dedicated to PWC owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, maintenance, for all SeaDoos, Waverunners, and Jet Skis.
Full Forum Listing
Explore Our Forums
Yamaha Jetski General PWC & Jetski Discussion Kawasaki Jetski Sea-Doo Jetski PWC Jetski Classifieds
Top