Personal Water Craft Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
24 Posts
make sure you start your engine first ,then turn the water on.then shut water off and rev the engine a couple times to get the extra water out.REMEMBER, engine on first then water on,then water off and then engine off!
 

·
Registered
Joined
·
24 Posts
A couple of hours after flushing the waverunner, I started it again and water continued on comming out. Shouldn't reving the engine a couple of times with the water off dry the engine out? Why is there still water comming up?
yes, give the motor a couple of revs to get out any extra water, but don't run the motor for more than 15 to 20 seconds with out the water hooked up any longer you could over heat the motor. When I flush my motor out I usually run my motor for about 5 min. to get out the salty water.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top