Personal Water Craft Forum banner
1 - 3 of 3 Posts

· Registered
3 Posts
Discussion Starter · #1 · (Edited)
Hello, I am rebuilding a xl1200 non-pv Yamaha and had a couple of questions. I have attached a couple of pics. One of the head can this be re-used the former engine broke a rod and caused some damage. I purchased a new case and a set of used cylinders. the cylinder shave a fresh bore but I noticed about 2mm from the top there is a scratch. Will this affect the cylinder?


1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.