Personal Water Craft Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
14 Posts
check the other posts, I thought someone stated the shaft size is different. also, would you be changing all the tub internals or just the motor?
 

·
Registered
Joined
·
285 Posts
go to New Jet Ski Parts and Used Jetski Parts - Jetskiparts.com and look up the breakdowns on both ski's. this might give you a idea if they will work or not. Don't know if motor mounts are the same or not? and how the electrical harness will work switching them around, I would think you could do it but better check it out to be sure, hate to see you buy and engine that you can't swap out.
 

·
Registered
Joined
·
323 Posts
No. the power valve motor wont fit in that ski. Dont know why you would want to do it anyway. But if you did do it, you would have to change the mounting points, also make them lower, get custom mounts. Then the carbs wont fit in and then you have NO CHANCE of getting the exhaust in.
 
1 - 4 of 4 Posts
Top