Personal Water Craft Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1
I just recently bought a 1992 Wave runner 650Q.

Two things though, there was exhaust blowing out of the top of the head of the engine. I noticed there was a threaded hole labeled "wash" so I put a bolt in it, was that the right thing to do?

There are two small rubber hose lines coming from the front, under the intake area, one runes to the gas tank, an over flow? but the other one was just laying there, where does it go? battery over flow?
 

·
Registered
Joined
·
323 Posts
Its a two stroke. Why are you changing the oil??? Does it have a separate oil tak with oil pump or is it pre-mix?? The wash thing is for flushing the engine after salt water use.
 

·
Registered
Joined
·
323 Posts
No gear oil. No gear box! No pump unit oil. Only pump grease in the short shart housing which you will find a grease nipple for somewhere near the back of the engine and pump unit grease in the pump vein. Only way to do that is to pull the pump unit apart and remove the cavitation cone and replace grease. But theres no oil anywhere.
 
1 - 7 of 7 Posts
Top