Personal Water Craft Forum banner

Going PreMix - What oil and what ratio?

3K views 0 replies 1 participant last post by  Mavrick 
#1 ·
I am deleting my oil pump and lines, and switching to pre-mix.

The ski in question is a 2000 XL800. Over on PWCToday.com they list different pre-mix ratios that are supposed to match what the stock oil pump puts out at wide open throttle. For the 800/1200 they say to mix it at 32:1.

Anyone out there with an 800/1200 running pre-mix? What ratio are you mixing at?

What oil should i be using to ensure above adequate lubrication?

What about break in, any special oil, or just mix it a little richer?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top