Personal Water Craft Forum banner
1 - 6 of 6 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
Ive got a 2000 yamaha gp1200r. i took the carb's off and cleaned them. I'm in the middle f re installing them. i can't get the cable that runs the oil pump to hook up to thelittle wheel that mounts to the carbs. its like the cable sucked in and is now to short. any help would be great. thanks in advance.
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.