Personal Water Craft Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Help me please I am new at this forum. I have XPLtd. I have damaged my impeler I have changed it intio a new one but my acceleration is still very bad, but top end speed is very good.When I accelerate my rpm goes up to 7000 but jet does not accelerate.If I start accelerating very slowly then accelerating from 20mph is very good to end speed (62mph).Can anyone give me any advice.

Thanks from Lithuania
 

·
Registered
Joined
·
163 Posts
OK, I'm not quite positive I understand if you're saying that it just takes a while to get to speed or if it's bogging down...

Lets work off of the slow acceleration and then go from there.

Based on the fact that you just put in a new impeller, you may have installed one with an incorrect pitch to the blades. If it's too steep you will loose acceleration.

How did you damage the first impeller?? You may have damaged other things at the same time...
 
1 - 2 of 2 Posts
Top