Personal Water Craft Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
My dad has a 2002 Virage i 800 Direct Injected PWC with about 42 hours on it. The ski has been running pretty good since he bought it until this year. Keep in mind that it has been winterized using the same method each year and has had no problems. While troubleshooting it I had the flush kit hooked up and noticed that there was a stream of water coming out of the side of the front cylinder. About mid-way up the cylinder on the intake side of the jug. What would cause a cylinder jug to get a hole in the side of it like this? Anybody know of a good place to buy a replacement and the gasket kit along with it.

Thanks,
Hoppy
 

·
Registered
Joined
·
2 Posts
I had same thing on a freedom it was caused by it coming loose. I just welded the crack reinstalled never had problem again.
 
1 - 2 of 2 Posts
Top