Personal Water Craft Forum banner
1 - 1 of 1 Posts

3 Posts
There should we water coming out with your exhaust gases. If there isnt, you have a water block in your exhuast expansion chamber.

Unscrew cooling elbow 52014 on the image diagram. check for any blockage to and from that elbow. or stick a small screwdriver in the hole where it screws into, it should go all the way through.

I had a small pebble stuck in the hole where 52014 screws into. It was blocking waterflow into the exuaust which burned up my rubber exuast hose.

always good to follow flush procedures to clean out your cooling system.


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.