Personal Water Craft Forum banner
1 - 2 of 2 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
i have a 640 barracuda runs great ,takes a lot to plane it ,then it runs great was told to check the chips looks great but it hass an 1/8 - 1/16 air gap between the blades and the wear ring. would this cause the problem i also have a 9996 montego checked the imp. on that one and it fits tight so i assume thats the problem. but they are different style props so i thought i would ask . i dont know much about jet drives

thanks in advance mike
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.