Personal Water Craft Forum banner
1 - 2 of 2 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
Ok i picked up this as a beater ski.The guy i got it from sucked up a huge rock and trashed the impeller.I can not figure out how to change the impeller.I have the shaft out with the rear housing still on it(part with cone shaped end) and dont know if that needs to be pressed off to get to a clip or???The impeller dont have any nut or sighn of something holding it on,but i dont have a book and am trying to do this with out spending alot of$.Any help would be great and pics would be awsome.Thanks
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.