Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
12 Posts
Discussion Starter · #1 ·
A few of the bolt heads for my intake grate were already snapped off, and I sprayed the remaining ones with PB Blaster, let sit for a while, sprayed some more, let sit more.. and was careful but snapped another off.. so I didn't even attempt on the others. I'd like to put a RIVA Top Loader grate somtime, or at least replace these bolts.. any suggestions? Would any type of bolt/screw extractor work, or would I have to drill these out and re-tap the holes?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.