Personal Water Craft Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
I am trying to get new pistons for my ski's and with the vernier calipers I seem to measure about 75mm but in my book I think it says that stock should be 76mm. I am getting a bunch of stuff from someone on e-bay and he has pistons that are for a .25 bored over motor. Everything online seems to say that stock should be 75 too. Is the Clymer wrong?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top