Personal Water Craft Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Hi all,

Just in the process of replace the jet pump with a reconditioned one which has an after market Solas Supra impeller on it. Before i installed the pump the impeller was spinning around nicely within the housing. After installing the impeller i tried to turn the engine over and it felt like something was seized. I took the pump off again and the engine fired up as normal. Upon inspection of the pump i noticed that the impeller would not spin around any more. I have take the housing of the impeller section and it still will not spin around.

Could it be a dodgy bearing or impeller installed incorrectly???

Any help would really be appreciated guys and girls.

Thanks

Darren
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top