Personal Water Craft Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
I also kept melting my exhaust hose on a 1100stx. It was because water was not flowing in the hose and out the rear exhaust.

On top of the first front muffler there is a small elbow screwed in with a cooling hose attached to it. Unscrew it and look inside there. I had a small rock stuck in mine causing water not to flow into the exhaust itself. I stuck a small screwdriver in the hole to get the rock out. Make sure you get whatever was stuck in there, out of the exhaust before you start it.

Also check and see if the lines that run back from that muffler elbow are clear to the T elbow under the manifold.

If everything is clear, you should see water come out the exhuast when you flush it.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top