Personal Water Craft Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a 1994 Kawasaki SuperSport. I am in the process of getting in ready for the summer. So I was working on it today (out of the water) and started the engine....but after about 5 seconds, the engine rpms stared increasing without me touching anything (including the throttle), so I pulled the lanyard to kill the motor...but the engine kept going!!! The engine ran for an additional 10 or so seconds after the lanyard had been pulled.

Any ideas as to what would cause that? I'd hate to get on the water and be unable to kill the engine!

Thanks in advance for any help.
 

·
Registered
Joined
·
13 Posts
same thing just happened with my 650sx the kill switch usually works fine but like you said i was flushing it same thing happened....funny thing is it only does it when i flush it. im hopping to find an answer too
 
1 - 2 of 2 Posts
Top