Personal Water Craft Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter #1
Hey guys, im new to the world pwc's but want to start upgrading performance. I have the riva d-plate, sensor chip, and aluminum hi flow exhaust tube for my 01 gp1200r. Is this stuff tricky to install? Should i have it installed by my shop? Will the carbs have to be set after all of this is in the ski? I guess im just a little aprehensive to dig right in and just looking for a little advice or encouragement.
Thanks!
Chris
 

·
Registered
Joined
·
209 Posts
NO...those items are the easiest to install... you dont need to mess with the carbs until you get heads and flame arrestors...... but when you do mess with the carbs you'll need t-handles, thats the only way you can adjust on the fly... especially around the stupid single pipe.
 
1 - 7 of 7 Posts
Top