Personal Water Craft Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I just purchased a 96' Polaris sl 700 and the front cylinder was rebuilt but the rear was not. I did a check on the compression of the two and the rear is lagging a little. Should I rebuild both or try to get it started and leave it for now? I'm rebuilding the carb now.Any advice on the low compression? I s it a major problem? Thanks.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top