Personal Water Craft Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
try priming it right in the carb and if it runs then check your fuel filter and clean the carbs making sure you poke all the little holes out with a small wire (unbraiding a bike cable and using the strands works good) if that does not work, then there may be an issue with your crank seals. one other thing i do just to make sure that the battery is good because i have had "new" batteries that where accually 4 years old. try boosting it with your car just so you an be sure its getting all the power it needs, I have seen some batteries that have good votage when they are sitting but the voltage drops to like 6 or 7 once you put load on it. hope this helps ya, good luck!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top