Personal Water Craft Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
227 Posts
Usually I take the pump off and the rope slides right off. The other thing I do is cut off the rope with a long chefs knife. Propane torch can also burn off the rope. Now that the screws are broken, you might have to leave it on and try another way. Might have to take it over to your service center.
 

·
Registered
Joined
·
227 Posts
That is your intake grate. It will channel water up to your impeller and pump. Needs to be there. Be careful with the torch but the rope should melt right away. The jet pump takes in water and pushes it out faster so the ski goes ahead. Service center might either replace the pump housing where the screws go into or extract them out, whatever is usually cheaper.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top