Personal Water Craft Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
19 Posts
??

soldering the wires and shrink wrappings a good idea but what if water gets in the hull and the wires are just laying in the water??running the oil pump would be alright just make sure it gets properly primed and run premix in the first tank of gas for breakin with no wot runs and vary the throttle.replace all the gray fuel line as well and redo the carbs
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top