I have a pre owned, 45 hours, 05 XLT1200 which ran fine several times. Now the starter engages for few turns then stops. The battery seems fine. We did have a water in the hull event with water up to the battery level. (need I say teenager...). This whole PWC thing is new to me so I don't know where to start looking.
New to PWC's- 05 XLT1200 won't start
1 - 2 of 2 Posts
Hydrolock!
Stop and take a breath. Don't attempt to start it again!!:thumbsdown:
1.Remove the spark plugs (all)
2.Get a towel and prepare to make a mess.
3.Don't put the towel down yet just press the start button and se if there is a rocket times 3 of water.
4.If so... put towel over spark plug holes and go to town until no more water comes out of the holes.
Email me after you do that and let me know what happened [email protected]:appl:
Stop and take a breath. Don't attempt to start it again!!:thumbsdown:
1.Remove the spark plugs (all)
2.Get a towel and prepare to make a mess.
3.Don't put the towel down yet just press the start button and se if there is a rocket times 3 of water.
4.If so... put towel over spark plug holes and go to town until no more water comes out of the holes.
Email me after you do that and let me know what happened [email protected]:appl:
1 - 2 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Personal Water Craft Forum
A forum community dedicated to PWC owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, maintenance, for all SeaDoos, Waverunners, and Jet Skis.
Full Forum Listing
Recommended Communities
Join now to ask and comment!
