Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
7 Posts
Discussion Starter · #1 ·
Hello Im new here. I have a 95 ZXI 900 that Im having rebuilt due to a center cyl lockup. I bought it like this and Im not sure what caused it but I want to remove the injector and do pre-mix. I just not sure what the ratio is and what all I need to do to convert the engine. Also, Is it ok just to put the oil strait into the tank then fill it up?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.