Personal Water Craft Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3,033 Posts
I've done it 2 ways:
1. Drain the fluids and lay the ski on its side, do one side of the hull, then roll it over and do the other. This way works well, but you have to do everything twice, so its time consuming
2. The last time I used a lift harness and 2 ton chain lift to lift the ski, so I could get underneath. I put my PWC stand under the back end as a safety measure and to help stabilize the ski from swaying back and forth. This worked OK, but it is really hard to work on you back all the time.

The best way to do it is to completely flip the ski upsidedown on the floor. Many guys rig up a way to protect the handlebars, etc.. This works the best for skis that don't weigh too much. I don't know about the zxi. The auto rotation thing might work, but I don't know where you would be able to make an attachment to the ski.
 

·
Registered
Joined
·
3,033 Posts
It might work if you can rig up something to attach to the stern eyes and bow eye. I would still put something underneath the middle to help support the weight, since I doubt that these points would hold the full weight of the ski. On my ski they are just attached to the thin fiberglass at the rear of the ski.
 
1 - 2 of 2 Posts
Top