Personal Water Craft Forum banner

Opening the electrical box

2K views 3 replies 3 participants last post by  Greasemonkey 
#1 ·
I have a 1994 Tigershark Barracuda 640 that has a stutter every now and then in the ignition. I can't get the electrical box (sealed shut) open to test the coils or even replace them. Does anyone know how to get the box open without damaging it?

It's a metal box that appears to be glued closed with a white sealant.
 
#4 ·
This is an old post, but you could unbolt from hull because voltage regulator is right by carrier bearing midway on driveshaft. Then maybe use a utility knife and only run it a 1/8” deep at most along outer edge because case isnt very thick then use a thin putty knife to help wedge/pry open gently. Goodluck, been there done that!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top