Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
16 Posts
Discussion Starter · #1 ·
Please help! got a 650A and 650B ones out of a superjet 93 the other a marine jet 93. whats the difference? :dunno:

I am marrying the parts to make one engine. the bottom end from the marine jet and the top end block and head from a superjet. can it be done ok or is there anything i need to know about it? :dunno:

i have replace the pistons and rings .50 oversized as the superjet block has been rebored. i want the married up engine to go back in my superjet. i have noticed on the engine mountings on the engine that the 650 t engine it is squared off. not sure if its to fit the hull?

im really confused, guess its late and im gonna give up till tomorrow. any help would be really appreciated :)
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.