Personal Water Craft Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Hey everyone I am new to the site and don't want to start a new thread for the same problem - nor do I want to hijack the thread. Mine is a '99 900 Tigershark, began to make a different sound running in the water, took it out of the water and looked at the impeller. It is tighter to the bottom and gapped at the top. Running out of the water have the metal tinny sound just as discribed in the thread. Pulling up on the shaft bearing while rulling it sounds alot better. Do you think it is just the bearing that i need to replace? Shim the motor up? There is a little play in the bearing so that leads me to think bearing.

Thanks
 
1 - 1 of 1 Posts
Top