Personal Water Craft Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Good thread.

One of my 650's just now began rattling when I was lubing & checking them out before heading to the lake for the first time of the season. They are on a trailer. One is quiet & the other rattles. (It's nice that I have two of them so I can compare...)

I had to replace a driveshaft a couple of years ago, but now I'm having a hard time pulling the drive off after removing the 4 bolts. Can anybody offer advice on how to loosen it? It should just slip out, right? And the drive shaft is splined and should come out along with the impeller & pump unit? (That's how I think I remember it...)

thanks,
 
1 - 1 of 1 Posts
Top