Joined
·
4 Posts
how do you memove rear seal on output side , and remove output shaft ???? seal is bad and sucking air
poaris 700 slt
Join the discussion
Recommended Reading
-
carb swap
Polaris Jetskii have a 1998 polaris 1050 with 40mm carbs will a 1999 genises 1200 carb rack bolt right on and work there saying my carbs are discountued- 0
- 103
-
scottybarber · updated
-
Polaris SL 700
Polaris JetskiHello, I have a chance to buy a SL 700 ski for $ 50.00, the guy said its for parts said has motor but maybe missing parts. Not sure if this is a deal or not, if anyone has a suggestion please let me know. Thanks- 2
- 287
-
2000 polaris virage battery problem
Polaris JetskiI have a 2000 polaris virage that ran great all summer and now just dies intermittently and the battery is dead or close to it? When I replace the battery it will start and runs great again. Until the next time???? Any ideas- 1
- 239
-
How do I flush my ski out
Polaris JetskiHi I have just bought a Polaris msx140 and can’t work out how to flush it out after using it. The seadoes down the club all have a plug that screws in on the rear but there is nothing like this on my ski can anyone help please- 0
- 228
-
No spark
Polaris JetskiHello All I have a 1997 SL700 DLX,it started for 30 seconds then stopped,since then I have no spark,changed plugs,checked to make sure it was getting gas,battery is fully charged,still no spark.Any ideas?? Thank-You for ANY help.- 1
- 280
Join now to ask and comment!