Personal Water Craft Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I have recently put on a new head gasket, and rebuilt the carburator. When it starts on land it idles fine. and you can rev the throttle for a second with no issues but it eventually cuts out and dies. Once it dies it takes a few turns of the starter to get it to fire again. Any ideas??
 

·
Registered
Joined
·
10 Posts
Discussion Starter #3
Not sure what you mean. It sounds right. A little rev to get it going then it idles fine for maybe 10 seconds then cuts like its out of gas but its not.
 

·
Registered
Joined
·
10 Posts
Discussion Starter #5
There is no Tach and i dont have one to measure it. It sounds perfect until just a few seconds later it cuts out.
 
1 - 6 of 6 Posts
Top