Personal Water Craft Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
285 Posts
pulling the pump out is just as easy, 10mm bolts to remove and slide the shaft back, install the dampaning coupler and slide it back together, while you have the pump off good time to take a dremil to the prop blades and take off any sharp edges. And inspect the bearing while your at it. NOTE: Employees cost alot to employ you have to charge a fair price because insurance, wages and taxes, maintaince, training and upkeep on a business arn't cheep.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top