Personal Water Craft Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
The shaft to my 2001 700XL Yahama waverunner needs to be taken off the impeller duct asssembly. Does that have to be presssed off and how would you advise.

Also for anyone interested I was able to get my intermediate housing loose from the intake duct assembly by use of mineral spirits, torch heating, prying, and beating with a hammer and a block of wood. When I put that back together I will use antiseize between the two joints.
 

·
Registered
Joined
·
13 Posts
Discussion Starter #2
The shaft to my 2001 700XL Yahama waverunner needs to be taken off the impeller duct asssembly. Does that have to be presssed off and how would you advise.

Also for anyone interested I was able to get my intermediate housing loose from the intake duct assembly by use of mineral spirits, torch heating, prying, and beating with a hammer and a block of wood. When I put that back together I will use antiseize between the two joints.
yes it had to be pressed off. thanks welder
 
1 - 2 of 2 Posts
Top