Personal Water Craft Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
I smoked the # 3 cylinder in my Wave Venture 1100. I guess it was due to oil issues. My plans are to bebuild the top end, carbs, fuel pump, deck the head and go to pre-mix. My questions are, who to buy from? What brand pistons and rings? Are there any performance tweaks i should look at ? I have it dissasembled and ready to get the parts so I can get to the machine shop. Thanks :) :D
 

·
Registered
Joined
·
5 Posts
I just did a top end on my 1100 trip. I bought a whole WSM top end kit for around 300. You can find these kits pretty easily on ebay, thats where i got mine. Just make sure to specify what bore size. Mine was .040
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top