Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
4 Posts
Discussion Starter · #1 ·
I have a 2000 Sea Doo. It was recently worked on and diode was replaced. However, the shop didn't clear the MAINT message on the screen. I was told there is a sequence of buttons I can push to clear the message.

Does anyone know what the sequence is so I can clear the message?


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.