Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
148 Posts
Discussion Starter · #1 ·
I brought my ski to Martins Custom Structures in Gloucester Virginia today for some addittional rod holders. After using it a couple of times since it was rigged I realized that all of of my rod holders were pitched out at an angle. This is not alway good when I am pulling into a dock or working the plies of a bridge. I pulled up to Albert's shop and in thirty minutes I had three more aluminum rod holders welded on to my jet ski in a vertical posistion. Now I think I have enough with a total of eleven. Here are a couple of pictures and this mornings sunrise;

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.