I recently purchased a bottom end off ebay and the seller said it was from a Seadoo 580, but the rod end diameter was a lot larger than the original. The bearing and piston pin is too small. Is this a 720 crank? Something different. The rest of the crank looked similar. Was there a different bearing that was larger to fill the space?
seadoo rod end diameter question
1 - 1 of 1 Posts
1 - 1 of 1 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Personal Water Craft Forum
A forum community dedicated to PWC owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, maintenance, for all SeaDoos, Waverunners, and Jet Skis.
Full Forum Listing
Recommended Communities
Join now to ask and comment!
