Joined
·
4 Posts
I'm getting ready to start a top end engine rebuild and need a good manual to guide me through the procees and identify part numbers etc.
Recomendations for a manual?
I'm planning to use an exchange service for the trashed cylinder and was planning to hone the other good cylinders and replace all the rings also.
These cylinders apparently have a Nickelsil (spelling?) sleave. Can you still just hone these to clean them up, or is that a No No? The two good cyclinders had a compresion of 135 psi + or -. What is the recomended proceedure to clean these up a little, or should I just leave them alone?
Thanks for all you help
Recomendations for a manual?
I'm planning to use an exchange service for the trashed cylinder and was planning to hone the other good cylinders and replace all the rings also.
These cylinders apparently have a Nickelsil (spelling?) sleave. Can you still just hone these to clean them up, or is that a No No? The two good cyclinders had a compresion of 135 psi + or -. What is the recomended proceedure to clean these up a little, or should I just leave them alone?
Thanks for all you help