slo

1 - 1 of 1 Posts

kawasakistx2007

Registered

Joined Aug 1, 2010

1 Posts

Discussion Starter • #1 • Aug 1, 2010

Today i let one of my kids on the jet ski (kawasaki stx 12f) I put in SLO, Then i got back on and put it back to FOP. I road around for a little bit and when i stoped it went to SLO by its self . does any body eles have this problem

1 - 1 of 1 Posts

Join the discussion

Recommended Reading

2008 STX-15F overheating issue

Kawasaki Jetski

Greetings All, I am having a strange issue with my 2008 Kawasaki STX-15F Jetski; when I go to run it in the morning; it runs great, and there is water coming out of the cooling port; after running it for about 1/2 - 1 hr, and run at idle, like I would do to dock it, steaming hot water spits out...
- 1
- 2K
- S
  SirBones · updated 13 d ago
2005 stx1500 kawasaki jet ski ski will only go to 5200 rpm

Kawasaki Jetski

Hello all: I have wrote a few post on this subject. I have some new thoughts on this. I have now replaced every input signal device that the ski has with the exception of TP sensor, but have metered it out and it says it good, replaced all injectors, all fuel lines and filter. Also stupid I...
- 0
- 315
- C
  cruiser222 · updated 28 d ago
Ultra 150 oil injection system

Kawasaki Jetski

I have an 2000 Ultra 150, I assume same motor as 2000 STX. I always premix about an ounce of oil to the gallon in addition to the what is provided by the oil pump, just for insurance when running at high rpm, because I understand the pump to be variable with speed but I worry about it providing...
- 1
- 180
- T
  t321sg · updated 1 mo ago
750 exhausts

Kawasaki Jetski

I am trying to get a green/big pin 750 engine going in a Sport Cruiser... I previously had small pin installed but blew it up. Trying to sort out the exhaust and need some help. I just purchased a green 750 exhaust manifold on ebay and when I got it home realized the opening to the head tube is...
- 3
- 150
- nichdiep · updated 2 mo ago
2000 kawasaki 1100 stx di oil flooding cylinders

Kawasaki Jetski

My dad bought his PwC brand new and right now it's only got 15hrs on it. He parked it years ago because when you try to crank it, the plugs foul out because the cylinders get flooded with oil and then it wont even spin over. To get it to spin over again, you have to pull the plugs and get the...
- 11
- 560
- C
  Cmn271 · updated 2 mo ago