Personal Water Craft Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
163 Posts
You will need the topend kit. It includes the gaskets, bearings, and wrist pins that you'll need to rebuild it correctly.

Try looking on ebay for that kit though, I bought one a few months ago for the 657 and it was only $199. The kit also includes the overbore dimensions that the machineshop will need to bored the cylinders to. Make certain that is done correctly and verify the dimensions afterwards if you can. If they make the fit too tight, you'll sieze a brand new rebuild pretty quick.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top