Personal Water Craft Forum banner
Cancel

Stator failure?

2415 Views 3 Replies 2 Participants Last post by  JUST-IN-TIME, 
H
I am a certified mechanic in Diesel and good automotive mechanic. New to the 2 cycle jet ski engine. Just overhauled a js 550 a6 engine. Gave it a 440 crank, 76 mm pistons, Pro Series connecting rods w/ oversized pin bearings. Got it all back together, was firing. Was setting up to time the stator and when I reassembled the flywheel, I lost spark. Any common mistakes that I could have made or good diagnostic ideas. Any help would be greatly appreciated.
Reply
Save
Like
1 - 2 of 4 Posts
H
No metal work bench

I have since removed the stator and had to repair the ground wire and found a wire supposed to go to one side of the coil broken. Not sure if I should repair it and reinstall or not. Anyone know where I can get it repaired or replaced for less than 100 bucks for a 87 550 js a6 Kawasaki.
Reply
Save
Like
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Personal Water Craft Forum
A forum community dedicated to PWC owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, maintenance, for all SeaDoos, Waverunners, and Jet Skis.
Full Forum Listing
Explore Our Forums
Yamaha Jetski General PWC & Jetski Discussion Kawasaki Jetski Sea-Doo Jetski PWC Jetski Classifieds
Top