Personal Water Craft Forum banner
1 - 2 of 2 Posts

· Registered
144 Posts
If you don't have the proper equipment, and haven't marked where the previous plate was set at for a starting point, then I would "strongly suggest" that you take it to a professional to set it up.

There is a very fine line between perfect timing advance, and complete piston meltdown. And if you set it on the side of caution you won't get the potential performance.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.