Personal Water Craft Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I recently purchased an 07 Superjet (bone stock). What would be the best ride plate/intake grate to buy to keep the ski from wanting to jump out of the water at full speed. I want the ski the ride in a straight line at full speed without it wanting to keep jumping. Any thoughts?
 

·
Registered
Joined
·
3 Posts
I know on my pre-08 SuperJets the Pro-Tec ride plate and the Worx scoop grate always seemed to be a good setup. Proper ride plate shimming always helps the boat to drive a bit better in rough water.

You should also try adding a little weight below the motor...this really helps since the SuperJets are so light.
 
1 - 3 of 3 Posts
Top