Personal Water Craft Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I had the studs out of the intake manifold shear off which is hard to believe, but I've got the carb off and the intake manifold has some brass parts attached to it and seems like it won't come out easily. I would guess these are the reed valves since it's a 2 cycle, but I'm down at the lake without a manual. Please help explain if I can wiggle this intake manifold out and get it to a machine shop to have it drill out and new studs set in.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.